How To Install A Butcher Block Countertop

What is the Best Wood to Make a Butcher Block?

Butcher block is made from slices of wood that are all glued together into thick slabs, made to withstand heavy daily use. They can be made from nearly any wood, but Nathan chose maple as this is most popular for butcher block counters because it is hard and durable.

What is the Best Finish for a Butcher Block?

Butcher block cannot be left unfinished as it will stain very easily. The only finish Nathan uses on butcher block is mineral oil, a food-safe option that is a must in the kitchen.

How to Make a DIY Butcher Block Countertop

It will take about 2-3 layers of finish to start and after that, it needs a layer applied about once a month. Butcher block countertops will give your kitchen a unique, rustic feel while making for a budget-friendly option.

Steps for Installing a Butcher Block Countertop:

Step 1: Disconnect the kitchen sink from the water supply and drain lines

Look under the countertop for clips or screws that might be securing the countertop to the cabinet and disconnect. Pry the laminate off

Step 2: Measure the cabinets

Be sure to include any overhang you would like the countertop to have. There’s usually an A and a B side to butcher block countertops. The B side will have knots and wood filler on it. So make sure to face the A side up.

Step 3: Cut the butcher block(s) to fit your cabinets

Nathan uses a track saw to cut the butcher block to size. To join two pieces together, Nathan creates a mortise using a Forstner bit. He goes in after with a chisel to clean up. A joint connector is used to connect the countertops. Carry the butcher block(s) back inside to install.

Step 4: Cut out a hole for the sink

Nathan uses a circular saw. He added a piece of strapping on the butcher block that was being cut, this is to prevent it from falling below.

Step 5: Secure the countertop

Use wood screws and glue to secure the countertop.

Step 6: Connect the sink

Get a licensed plumber to come in and connect the sink.

Step 7: Apply a finish to the butcher block

Nathan suggests mineral oil, as this is food safe. For countertops, 2-3 layers should be adequate before any use. After that, you should reapply every month. Apply a generous amount in one area. Use a squeegee to spread it out. Use a rag to buff it out.

Resources

Nathan installed Unfinished Maple Butcher Block Countertop, which is manufactured by Hardwood Reflections. He ordered an 8’ and 4’ section. To cut the butcher block to size, Nathan used a circular track saw. To secure the two sections together, Nathan used Gorilla wood glue and joint connectors. In the segment in the Barn after the project, Nathan demonstrated how to finish butcher block using Food Grade Cutting Board Oil, which is manufactured by Howard Products.

Materials

Butcher block Wood glue Joint connectors Food grade cutting board oil

Tools